What is the requirement of heat transfer printing for environment and temperature?

No matter what kind of work we are doing, we should do it as required, so that there will not be so many problems, especially in the heat transfer process. As the saying goes, the details determine the success or failure, so we need to know clearly, when using the heat transfer equipment, the operation is correct, so what is the requirement of the heat transfer process for the environment and the temperature?

We can know the different information requirements of transfer printing temperature vary, with plastic, hard rubber class ABS, benzene, and strength, etc.) than the soft glue class (PP, PE, etc.) required for transfer printing about low temperature 20 ℃ or so. (thermometer and exploration in silicon roller, rubber sheet surface between 90 ℃ -- 120 ℃), and PVC required lower temperature (about 60 ℃ - 80 ℃). The right operation method can ensure that our work smoothly, because of the heat transfer process of heat from a layer of heat-resistant thin film and substrates, and contact time is not long (rubber roller transfer about 1 cm / 0.5 1 seconds, rubber sheet direct pressure about 1-4 seconds/time), will cause no print objects deformation, but if the substrates for soft rubber plate of less than 0.5 mm, will have a small deformation.

The heat transfer printing process first requires that the site has a clean or less dusty environment to prevent the dust from falling on the substrate or transfer film surface, so that there is a defect in the image; Substrates surface shall be without oil, moisture, dust, workers operation had better wear cotton gloves substrates, in order to protect the clean clean, transfer content air dry, water filter to water every day, to ensure that gas path smooth, a cylinder is normal.

That is what is thermal transfer processing to the requirement of environment and temperature, we can now know is that not all of the environment and the temperature, can carry on the processing, is to have certain requirements, this is good, want to machining good thermal transfer, thermal transfer equipment to choose good.